Fixture Menu - Elation PLATINUM BEAM 15R Manual

9. CONTROL BOARD
The Control Board offers several features: you can simply set the starting address, run
the pre-programmed program or make a reset.
The main menu is accessed by pressing and holding down the
display starts flashing. Browse through the menu by pressing the
-button, -button or
menu function. You can change the selection by pressing the
-button, -button or
-button. You can exit the menu at any time by pressing the
provided are described in the following sections. it will exit from flash 10 seconds after the
last key function has been pressed. The fixture menu commands and functions are
described in the following section.
To access the display menu via the internal battery, press the DC switch button
for 2seconds; To shut off the display immediately, choose the commend " Reset
All" menu and press "Enter" button, otherwise, the display will automatically
switch off about 1 minute from last button press.
Set Dmx Address
Dmx Value
Slave Mode
Auto Program
Sound Control
Time
Information
-button. Press the Enter-button to select the desired
-button. Confirm every selection by pressing the
A001~AXXX
PAN......
Slave1,Slave2,Slave3
Master / Alone
Master / Alone
Current Time XXXX(Hours)
Total Run Time XXXX(Hours)
Last Run Time XXXX(Hours)
Lamp Hours XXXX(Hours)
Lamp Off Time XXXX(Minute)
LastRun Password=XXX
Password ON/OFF
Clean Last Run Password=XXX
LampTime ON/OFF
Password
Clean Lamp Time
Platinum Beam 15R™
-button until the
-button,
-button,
-button. The functions
DMX address
setting
DMX value display
Slave setting
Auto program
Music control
Power on running
time
Fixture running time
Fixture Last times
clear
Lamp running time
Lamp off time
Timer Password
038
Clear Fixture Last
time
Lamp Password