Connecting The Server To The Mains; The Server - Fujitsu PRIMERGY TX300 S5 Operating Manual

Hardware installation
The corresponding indicators are explained in section
page 73.
I
Some of the devices connected require special software (e.g. drivers)
(see documentation for the connected device).
Ê Connect the devices.
Three additional USB ports are located on the front of the server (see figure
on page 68).
I
If components with large power requirements (e.g. external USB hard
disk drives) are connected simultaneously, these USB ports may be
switched off.
Connecting the keyboard, mouse and monitor
Ê Connect the monitor, the keyboard and the mouse to the standard ports of
the server (see figure
Ê Connect the power cable of the monitor to a grounded mains outlet of the in-
house mains and/or to the mains socket strip of the rack.
V
CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
4.5

Connecting the server to the mains

In its basic configuration level the server has a hot-plug power supply unit. A
second hot-plug power supply unit can be added to ensure a redundant power
supply. If a defect occurs in one power supply unit, the other power supply unit
ensures unimpaired further operation.
V
CAUTION!
The power supply unit automatically adapts to a mains voltage between
100 V - 240 V. Make sure that your local mains voltage is within the
range.
TX300 S5
Connecting the server to the mains
15 on page 60).
Operating manual
"Rear of server" on
21
61