Non-hot-plug components
Figure 39: Installing an expansion card
Ê Carefully press the new expansion card into the relevant slot on the system
board (1) until it clicks into place.
Ê Fit the clip onto the slot cover so that the pin fits into the hole.
Ê Push the clip under the metal nose until it clicks into place.
Ê Swing the lever (2) downwards into its locking position.
Ê Reconnect all cables to the expansion card.
Ê Replace the left side cover (floorstand model) or the housing cover (rack
model) (see
section "Opening/closing the housing" on page
110
2
1
Operating manual
CSS components
111).
TX300 S5