Fujitsu PRIMERGY TX300 S5 Operating Manual page 62

Connecting the server to the mains
2
2
Figure 16: Connecting the server to the mains (example: rack model)
Ê Connect the insulated connector of the power cable to power supply unit of
the server (1), and the power plug to a grounded mains outlet (2) of the in-
house mains and/or into the mains socket strip of the rack (see Technical
Manual of the rack).
I
A phase redundancy in the power supply of the server can be set up if
two hot-plug power supply units are installed.
In this case the two power supply units are directly connected either to
two different phases or two different power circuits of the in-house mains.
62 Operating manual
Hardware installation
1
1
TX300 S5