Id Card; Controls - Fujitsu PRIMERGY TX300 S5 Operating Manual

Starting up and operation
5.2.1.1

ID card

You can pull out the ID card as far as it will go and push it back in again.
The ID card contains various system information, such as the product name,
serial number and MAC addresses.
5.2.1.2

Controls

On/Off button
When the system is switched off, it can be switched on again by
pressing the On/Off button.
When the system is operating, pressing the On/Off button will
switch off the system.
I
NMI button
NMI
V
Reset button
RST
Pressing the reset button reboots the system.
V
ID button
ID
Lights up (blue) on the front and on the rear of the server when the
ID button is pressed. Both ID indicators are synchronized.
TX300 S5
The On/Off button does not disconnect the server from the
mains voltage. To disconnect from the mains completely,
remove the power plug(s).
CAUTION!
Do not press! Risk of loss of data! The NMI button may only
be used by service.
CAUTION!
Risk of loss of data!
Operating manual
Controls and indicators
69