Installation In Classic Rack - Fujitsu PRIMERGY TX300 S5 Operating Manual

Installing/removing the rack model
The following steps can be carried out by one person only.
Ê Press the safety springs (5) on both telescopic rails and slide the server as
far as it will go into the rack (6).
Ê Fasten the server using two knurled screws (7).
Ê Route the cables as described in the technical manual for the rack in
question with the server pushed in.
To remove the server, follow this procedure in reverse.
4.3.3

Installation in Classic Rack

A special conversion kit (S26361-F1331-L200 without cable arm or S26361-
F1331-L300 with cable arm) is needed for fitting in the Classic (19 inch
42/23 HU) rack:
– One support system on the left and one on the right
– Articulated cable guide
– Protective hose for fiber channel fiber optic cable
I
General information about rack installation can be found in the Technical
Manual for the Classic (19 inch) rack and in the leaflet that accompanies
the conversion kit.
Ê Mark the position of the attachment points for the support systems and for
the server (front panel) on the support uprights (four height units).
Ê Place the spring nuts for fixing the adapters in the groove on the support
uprights at the marked fixing points.
Ê Place the M5 spring nuts for securing the server in the groove on the front
faces of the front support uprights.
Ê Adjust the position of the nuts in the groove until they engage at the correct
position.
50 Operating manual
Hardware installation
TX300 S5