Mitel 5320 Reference Manual page 36

a networkWCS Hosted PBX desk phone to ensure you can log into
•
the extension you have assigned to the cordless, which ensures that
the extension and PIN are valid within networkWCS Hosted PBX .
When rebooting the networkWCS Hosted PBX cordless handsets you
•
need to briefly lift the handset(s) from their cradles and place them back on
the cradles. On their display you should see Searching for Gateway.
• If a phone is freezing or giving you problems try removing the battery for a
few seconds, replacing it, and then rebooting the gateway to default settings
and begin again.
• If you've accidently put in an IPEI in an incorrect spot and want to change it:
• Change it to the correct IPEI
• If there is no handset attached to that handset replace the IPEI field
with zeroes
Notes
• The Gateway only supports three simultaneous calls. Any further attempt to
establish a call results in the handset receiving a busy tone.
• Press and Hold Reset on the Gateway for more than 30 seconds to reset its
default values.
• Press and Hold Reset on the Gateway for five seconds to restore to a non-
default values.
• To register multiple handsets, manually enter the IPEIs into the Telephony
settings page via the web interface.
• Every time a new handset is added, the Gateway needs to be rebooted.
• A new handset cannot be registered if another handset is already on a call
because the Gateway cannot be rebooted.
• If a prefix digit is required to dial internal or external calls that have been
logged, you cannot dial directly from the call log. This is a common problem
with call log capabilities.
30
Mitel IP Phone Reference Guide
Using Phones