Mitel 5320 Reference Manual page 30

14. Press Yes.
15. Select Default Gateway
16. Enter default gateway IP
17. Press OK.
Save? appears in the display.
18. Press Yes
19. Press Back.
You are prompted to reset the gateway (stand).
20. Press Yes.
21. Press Back repeatedly to return to the main display.
After several seconds, Searching for Gateway appears in the handset main
display. It takes approximately 30 seconds for the stand to reset.
After the stand resets, it is configured with the static IP address and subnet mask.
Configure SIP domain appears in the handset main display.
Configure Handsets via IP-DECT Stand Configurator Web Interface
You access the IP-DECT Stand Configurator by entering the IP-address of the handset
into the address field on a web browser, such as Internet Explorer on your PC. The
following procedure covers the minimum configuration required to set up the handsets:
1. Press the Volume Up key on the side of the 5610 Cordless Handset to enter the
system status display.
The display shows the MAC address of the handset and the IP address of the IP
DECT Stand. Note that the Boot Status of the handset is displayed as Failed.
Ignore the displayed boot status because it is not accurate.
2. Record the IP address of the DECT stand, which is shown in the display.
_______________________________
3. Obtain and record the Handset IDs (IPEIs) on each handset.
a. Press OK to access the main menu.
b. Select Settings.
c. Press OK.
d. Select Handset ID.
e. Press OK.
f. The handset IPEI is displayed.
g. Record the IPEI.
Handset 1 IPEI: _______________________________
Handset 2 IPEI: _______________________________
Handset 3 IPEI: _______________________________
Handset 4 IPEI: _______________________________
24
Mitel IP Phone Reference Guide
Using Phones