Mitel 5320 Reference Manual page 26

Once you have a cordless base attached to the networkWCS Hosted PBX Desk
Phone you can no longer daisy chain it to another device.
3. Plug the cradle power cord into an electrical outlet.
4. Insert the included battery into the cordless.
5. Place the cordless on the stand to charge it.
6. You can register the repeater automatically or manually.
• Auto Registration
a. Ensure that the repeater is switched off (disconnect the power plug).
b. Set the base station in registration mode. Press reset key on back of the
base.
c. Switch on the repeater (connect the power plug).
The LED on the repeater flashes. After a short time the LED stays on
permanently indicating that registration is complete and the unit is ready
for operation.
If the registration is not immediately successful, the LED flashes continuously.
In this case repeat the procedure.
d. Before reinstalling the repeater (for example at another base station)
reset the repeater as follows:
i. Switch off the unit (disconnect the power plug).
ii. Switch off the unit for 1-5 seconds and switch on again.
iii. Switch of the unit for 25-35 seconds and switch on again.
Now the repeater is ready for a new auto registration.
• Manual Registration
You need to do this for each repeater and you need a networkWCS
Hosted PBX phone accessible to you to complete this task.
a. Set the repeater in registration mode
i. Insert the repeaters power plug for 1-5 seconds in the socket and
then remove it.
ii. Insert it once more and leave it there.
You now have five minutes to carry out the registration. If not
complete by this point you must start anew.
iii. Press the reset button on the back of the base to set it in registration
mode.
20
Mitel IP Phone Reference Guide
Using Phones