Table of Contents
Advertisement
About the Auto Memory Submenu
NOTE: For information on using the web-based user interface to enable or disable the
auto memory feature, see the
When the
settings of the incoming signal that is connected to each input. When the same input
signal is detected again, the stored picture settings are recalled from memory and are
automatically applied to the appropriate input.
The table below details the picture settings that are saved when the auto memory feature is
enabled.
Auto Memory Saved Settings
Primary Menu
Input Config
Picture Control
When the
as a new source. Input presets can be used in place of using the auto memory feature if
desired.
NOTE: For information on using input presets, see the
Presets" section on page 82 or see "Presets" on page 140 of the
Response Table for SIS
"Encoder Settings
submenu is set to
Auto Memory
Saved Settings
Film Detect
Horizontal Start
Vertical Start
Total Pixels
Horizontal Position
Vertical Position
Horizontal Size
Vertical Size
Brightness
submenu is set to
Auto Memory
Commands" section.
Page" section on page 88.
(default), the SME 100 stores the picture
On
Pixel Phase
Horizontal Active Pixels
Vertical Active Lines
Contrast
Color
Tint
Detail
Zoom
, the SME 100 will treat every applied input
Off
"Using User and Input
SME 100 • Front Panel Operation
"Command and
38
Advertisement
Table of Contents
