Installation (Qualified Technicians Only); Fireplace Size Requirements - SCAN DSA 4 Instructions For Installation And Use Manual

INSTALLATION
4.
The Scan DSA 4 is approved for installation into a masonry fireplace that conforms to the
requirements of the Standard of Chimneys, Fireplaces, Vents and Solid Fuel Burning appliances,
N.F.P.A. 211 (Latest Edition) or applicable National, Provincial, State or local codes. In Canada, the
installation must conform to CAN/CSA-B365, Installation Code for Solid-Fuel-Burning Appliances
and Equipment.
In the U.S. only, the Scan DSA 4 is approved for installation into a factory-built, zero-clearance fireplace
and chimney listed to UL 127.
WARNING: Check all local building and safety codes before the installation. The installation
instructions and appropriate code requirements must be followed exactly and without compromise.
Alterations to the fireplace are not allowed. Do not connect the fireplace to a chimney system serving
another fireplace or stove, appliance or any air distribution duct. Please read this entire manual before
you install and use your new room heater. Failure to follow instructions may result in property
damage, bodily injury, or even death, and will void the manufacturers warranty.
The fireplace must be connected to factory built UL 103HT chimney in USA only or a code approved
masonry chimney with a flue liner.
If you plan to vent your fireplace into an existing masonry chimney, have it inspected by a local fire
marshal or qualified installer. Remember that the chimney and its location on the roof heavily
influence a fireplace's performance. An oversized flue may not provide effective draw, and a flue liner
may be required. (See: draft requirements). Consult your dealer or qualified installer before final
selection is made.

4.1 Fireplace size requirements

(Qualified technicians only)
Valid for USA:
Minimum Fireplace Size
Masonry
Fireplace
A: 21 1/4" / 540 mm
B: 24" / 610 mm
C: 15 3/4"/ 400 mm
E: See page 8
A = Height
B = Width
C = Depth
E = Hearth Protection Depth
7