Surround Panel Installation (See Part Numbers Below) - SCAN DSA 4 Instructions For Installation And Use Manual

Fireplace insert
Table of Contents

Advertisement

4.7 Factory-built, Zero –clearance Fireplace ( U.S. ONLY )
The Scan DSA 4 may be installed into a factory-built, prefabricated fireplace in the U.S. only.
The factory-built • replace and its chimney must be listed per UL 127.
Warning: Under no circumstances is this heater to be installed in a makeshift or "temporary" manner.
Note: Most factory-built chimney manufacturers offer stainless steel chimney liners, either flexible or
rigid. Installation must conform to the manufacturer's instructions.
NOTE: The fully-lined chimney shown below may be used with a factory built or masonry fireplace. All
requirements in the section "Masonry Fireplace Requirements" must be fulfilled prior to installation.
4.7

Surround Panel Installation (see part numbers below)

Surround panel size is determined by the type of installation and the size of the fireplace opening.
Direct and positive connections do not require insulation or panels that overlap the fireplace opening
(panels that overlap the fireplace opening are usually more attractive). Any questions on selection of
the surround panels should be directed towards your dealer. The table below details the size of the
surround panels when installed.
Surround Panel Size
I" Surround (4-Sided)
4" Surround (4-Sided)
9" Surround (3-Sided)
11" Surround (3-Sided)
The surround panels can be installed both before and after the fireplace has been placed depending
on the installation conditions.
A = Install a non-combustible cover plate to vent water
from entering the chimney.
B = Combustible mantle
C = Surround panels
D = See the section "Insert Placement Requirements"
for minimum clearances and hearth requirement.
E = Cap (prevents water from entering)
F = Flue liner
G = The liner must be stainless steel connector
or flexible vent. Follow the liner manufacturer's
instructions for installation and support.
H = Airtight insulated clean-out
I = Remove damper or wire it open.
Overall Dimensions
25 3/4" x 22 3/4"
31 1/2" x 22 3/4"
42" x 29"
46" x 32"
BLACK
GRAY
157080
157081
157082
157083
157084
157085
157086
157087
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents