Installation (Qualified Technicians Only); Fireplace Size Requirements; Fireplace Placement Requirements - SCAN DSA 4 Instructions For Use Manual

4. INSTALLATION
WARNING: Check all local building and safety codes before the installation. The installation
instructions and appropriate code requirements must be followed exactly and without
compromise. Alterations to the fireplace are not allowed. Do not connect the fireplace to a
chimney system serving another fireplace or stove, appliance or any air distribution duct. Please
read this entire manual before you install and use your new room heater. Failure to follow
instructions may result in property damage, bodily injury, or even death, and will void the
manufacturers warranty.
The fireplace must be connected to factory built UL 103HT chimney in USA only or a code
approved masonry chimney with a flue liner.
If you plan to vent your fireplace into an existing masonry chimney, have it inspected by a local
fire marshal or qualified installer. Remember that the chimney and its location on the roof
heavily influence a fireplace's performance. An oversized flue may not provide effective draw,
and a flue liner may be required. (See: draft requirements). Consult your dealer or qualified
installer before final selection is made.

4.1 Fireplace size requirements

NOTE: Allow extra room for installation, especially above the insert when using a direct of
positive connection.

4.2 Fireplace placement requirements

The fireplace must be placed so that no combustibles are within, or can swing within (e.g.
drapers doors), 36" (915 mm) of the front of the fireplace. Fireplace and hearth must be installed
on a level, secure floor. The minimum clearances, facing, and hearth requirements in the
illustration above must bet met
(Qualified technicians only)
Valid for USA:
Minimum Fireplace Size
Masonry
Fireplace
A: 21¼" / 540 mm
B: 24" / 610 mm
C: 15¾"/ 400 mm
D: See page 8
A = Height
B = Width
C = Depth
E = See page 8
Page 7