Ending Calls - Mitel 6865i User Manual

Setting Up Multiple Conferences (for Sylantro Call Manager only)
Note:
The 6865i is limited to 9 conferences (a single conference each on lines 1 through 9).
1. Start Conference 1 using the procedures in the previous section,
(for Sylantro and BroadSoft Call
2. When you are finished adding all required parties to Conference 1, press an available Line key to start Conference 2.
You are Party 1 on Conference 2. Call Party 2.
3. When Party 2 answers, press the
4. Press an available Line key.
5. Call Party 3 for Conference 2.
6. When Party 3 answers, press the
You now have two active conferences on two different lines.
Note:
When you are connected to multiple conference calls, and you put a conference on hold, the conference may be on
hold for a limited period of time before it is disconnected. Contact your System Administrator for more information.
If any party in a conference hangs up (including the party that began the conference), all other parties in the conference
are still connected.
Joining Additional Parties to Active Conferences
In centralized conferencing, you can join multiple incoming or outgoing calls to active conferences. Before following this
procedure, at least one active conference must exist on your phone.
1. As Party 1, pickup the handset or press the
2. Call Party 2 by dialing their number (or answer an incoming call of a Party).
3. Wait for Party 2 to answer. When Party 2 answers, you can consult with them before adding them to the conference.
4. Press the key.
5. Press the Line key that has the active conference.
6. Press the key again to join the parties to the active conference.
Ending a Conference and Transferring Remaining Parties
The 6865i allows a host to drop from a 3-way conference and let the other two parties remain connected. If you are the
host of a conference and want to leave that conferencepress the
conference but the remaining parties are still connected to the conference.
Note:
The Caller ID of the dropped host still displays on the remaining parties' phones.

Ending Calls

IP Phone UI
To end a call, you first need to connect or reconnect to the call if not already connected (for example, if your caller is on hold).
Press to end the call. If connected through the handset, you can also place the handset back on hook to end the
call.
41-001566-00 REV00 – 10.2014
Managers)".
key.
key to join Parties 1 (which is yourself ), Party 2, and Party 3 on Conference 2.
key.
"Setting Up a Conference and Adding Multiple Parties
Leave key on the phone. Your phone leaves the 3-way
3
Handling Calls
113