Paging Key - Mitel 6865i User Manual

Paging Key

You can configure a Paging key on the phone that allows you to send a Real Time Transport Protocol (RTP) stream to pre-
configured multicast address(es) without involving SIP signalling. You enter a multicast IP address(es) and a port number
for the Paging key, that when pressed, initiates an outgoing multicast RTP session. This is called Group Paging on the IP
phones.
You can also specify group paging RTP addresses that the phone listens for when receiving RTP streams. You can specify
up to 5 listening multicast addresses at the path, Basic Settings > Preferences > Group Paging RTP Settings.
For more information about Group Paging and how it works, and to specify multicast addresses, see
on page 155.
Configuring a Paging Key
Mitel Web UI
1. Click on Operation > Programmable Keys.
or
Click on Operation > Expansion Module <N>.
Programmable Keys
2. Select from Key 1 through Key 8.
3. In the Type field, select Paging.
4. In the Value field, enter a multicast IP address and a port number for the Paging key. When you press this key, the
phone initiates an outgoing multicast RTP session to the specified address using the specified port (e.g.
239.0.1.15:10000).
Note:
The Value field allows for one multicast address entry only.
5. To receive RTP steams for Group Paging, you must also configure the Paging Listen Addresses parameter at the path,
Basic Settings > Preferences > Group Paging RTP Settings. For more information about setting this parameter, see
RTP Paging" on page 155.
6. Click Save Settings.
41-001566-00 REV00 – 10.2014
Line Keys and Programmable Keys
"Group RTP Paging"
"Group
95