Blf/List Key - Mitel 6865i User Manual

BLF/List Key

Note:
For use with the BroadSoft BroadWorks Release 13 or higher platform only. Your System Administrator must have
BLF/List enabled on the BroadWorks call manager. Contact your System Administrator for more information.
The BLF/List feature on the IP phones is specifically designed to support the BroadSoft BroadWorks Release 13 Busy Lamp
Field feature.
This feature allows the IP phone to subscribe to a list of monitored users defined through the BroadWorks web portal.
In addition to monitoring the idle and busy state, the BLF/List feature also supports the ringing state. When the monitored
user is idle, the corresponding key's LED is off. When the monitored user's phone is ringing, the corresponding key's LED
flashes. Finally, when the monitored user on an active call or is attempting to make a call, the corresponding key's LED
turns solid.
Notes:
• You can use a BLF/List-configured key to automatically dial out to the configured extension.
• The BroadWorks BLF feature is not the same as the BroadWorks Shared Call Appearance (SCA) feature and does not
permit call control over the monitored extension.
Configuring a BLF/List Key Using the Mitel Web UI
If you set a key to use BLF/List, you must also enter a BLF List URI at Operation > Programmable Keys > Services. The BLF
List URI is the name of the BLF list defined on the BroadSoft BroadWorks Busy Lamp field page for your particular user. For
example, sip:9@192.168.104.13. The value of the BLF List URI parameter must match the list name configured. Otherwise,
no values display on the 6865i screen and the feature is disabled.
Mitel Web UI
1. Click on Operation > Programmable Keys.
or
Click on Operation > Expansion Module <N>.
Programmable Keys
2. Select from Key 1 through Key 8.
3. In the Type field, select BLF/List (BroadSoft BroadWorks).
41-001566-00 REV00 – 10.2014
Line Keys and Programmable Keys
61