Operation After Setting Delay Time - Korg SDD-200 Owner's Manual

! PROG NO.
- U
' 1
I DATA/T1ME(ms
1
s J
Delay time (measured time)
31 Press the REC switch or foot switch again. The delay
time will then be set as the time between the last two
trigger inputs.
The delay time setting will be shown on the display.
You can now continue performing using the new
delay time.
NOTE:
If the time between triggers exceeds the maximum
(1092ms in x 1 mode or 4368ms in x4 mode) then
the display stops and the delay time is set as that
maximum figure.
}. OPERATION AFTER
SETTING DELAY TIME
CMCCCAU
FREO MTENSTTY TMEX4 PROG/WM
000
PftOGNO. j| OATA/TlMEtms)
EFFECT FEEDBACK TME WWTt
BE □
-S' IS3 I
PROGRAMMER
Parameter values can be
cnanged while pressing these _
switches.
• Editing Parameters
After setting the delay time, you can edit the various
parameters whose switch LEDs are flashing (REC,
INTENSITY, EFFECT, FEEDBACK). To edit a para
meter, depress its switch and at the same time turn
the INCREMENTAL CONTROL knob.
Parameter values can be changed while pressing
these switches.
Shows delay time setting.
Turn to adjust parameter value (while keeping para
meter switch depressed)
• To return to the time mode
Press the TIME x4 switch to return to the time
mode. This takes you back to step [2].
• To reset the delay time
Return to stepd).
• To return to delay mode from trigger overdub mode.
Press the TRIG OVERDUB switch so that is LED
goes out.
This returns you to the delay mode. The delay time
and time mode (x 1 or x4) values set in the trigger
overdub mode are retained.
Other parameter values are those of the delay mode.