Korg SDD-200 Owner's Manual page 38

"~" ~~ — — — — — — __ _ ,
'VELOCITY (NOTE ON) data: MIDI NOTE ON data "I
tells when a key is played, which key is played, and
how hard it is played. VELOCITY data is the part of
the NOTE ON data that indicates how hard the key
is played.
■=L
I How to set MIDI data processing parameters.
Follow the steps below to set the SDD-2000 to re
spond to MIDI NOTE OFF and/or VELOCITY data or
to ignore it.
I Press the MIDI switch and at the same time press
the SEQ (sequencer) or SAMPLING switch.
S) Display shows current settings.
Pressing the REC switch toggles the setting be
tween "response" and "no response" to NOTE OFF
data. The upper LED bar lights up when set to re
spond to NOTE OFF data.
• Pressing the TRIG OVERDUB switch toggles the set
ting between "response" and ttno response" to
VELOCITY data. The lower LED bar lights up when
set to respond to VELOCITY data.
Then, the time mode can be changed by pressing the
TIME x4 switch.
• These settings are retained when the power is turned
off.
4. REC CALIBRATION.
When using the sequencer or sampling modes with a
MIDI keyboard, reproduced pitch may not be quite right
In this case, you can have the SDD-2000 calibrate itself
to achieve pitch accuracy. This procedure is called REC
CALIBRATION. It is useful to perform REC CALIBRA
TION before recording and after adjusting the rear
panel TUNE control.
REC CALIBRATION can be performed in the recording
standby condition and during playback. The SDD-2000
also performs REC CALIBRATION automatically im
mediately after recording.
© Press MIDI switch
® Press either or these switcnes
I PROG NO. 11 DATA/TIME??
This bar (LED) illuminates
when set to respond to VELO
CITY data.
This bar (LED) illuminates
when set to respond to NOTE
OFF data.
38