Operation After Recording - Korg SDD-200 Owner's Manual

.3. OPERATION AFTER RECORDING
(DURING PLAYBACK)
FWEO
TMCX4 FflOG/ftUIA
IggQG_"Q 1 I DATA/TIMElmt) "1
EfFCCT FICDBACK 7WK WfVTE
,0 0 0, D
r u o i o u
PROGRAMMER
Frequency, intensity, effect,
and time LEDs are flashing.
> Editing Parameters
After setting the delay time, you can edit the various
parameters whose switch LEDs are flashing.
Press the switch for the parameter that you wish to
edit. While the switch is depressed, the display will
show the present value for that parameter, and the
value can be adjusted by turning the INCREMENTAL
CONTROL knob.
! ^
Time value after editing.
... 'i
■ -i
■■■MB
i
Time value before editing.
■ After editing, this Domon
is no longer reproduced.
> Editing the Time Parameter
After a recording has been made, you can shorten
the length of the recording by editing the TIME
parameter. This shaves off the recording from the
end. To reduce the length of a recording, hold down
the TIME switch and turn the INCREMENTAL CON
TROL knob.
, ' * Note that recordings can only be made shorter; I
I they can not be made longer than the original j
I recording time.
NOTE
In the sampling mode, sound will no longer be
reproduced if you edit the time parameter so that
the time value is reduced to around 120ms in the
x 4 mode or 30ms in the x 1 mode.
• To return to the delay mode:
Press the presently selected mode switch (SEQ or
SAMPLING) so that its LED goes out. This returns
you to the delay mode.
Frequency, intensity, and effect parameter values
are carried over into the delay mode.