Korg SDD-200 Owner's Manual page 22

DIGITAL DELAY MODE
B. Foot Switch Method
Before turning on the power, connect a foot switch
to the rear panel PROG UP Jack.
The program number will advance by one each time
the foot switch is depressed. (This is effective
regardless of the position of the PROG/PARA
switch.)
NEC PHOGUP CANCEL
Korg PS-1
foot switch, etc.
C. MIDI Data Method
Before turning on the power, connect a MIDI
keyboard or other MIDI control device. Connect the
extemal MIDI unit's MIDI OUT jack to the SDD-2000's
MIDI IN jack.
3] Turn on MIDI switch on SDD-2000 (so the LED il
luminates).
g] Select the MIDI receive channel by the method de
scribed below. The selected channel must match the
channel(s) to which the connected keyboard (or other
unit) can send. Then a change in the program
number on the keyboard will cause a change in the
program number on the SDD-2000.
From MIOI OUT jack
MO THRU MO IN TUNE
■6
» %
This LED on.-
• SETTING THE MIDI RECEIVE CHANNEL
T While pressing on the MIDI switch, slowly turn the
INCREMENTAL CONTROL knob one step. The dis
play will then show the previously selected MIDI
receive channel number.
• When the power is turned on the SDD-2000 is initially
in the OMNI mode. But it switches to OMNI OFF as
soon as this procedure is performed.
[2] If the displayed channel number is not what you
want, turn the INCREMENTAL CONTROL knob to
select your desired MIDI channel.
S Release the MIDI switch.
pPWOGNO.
DAWTlM£(m«)
O O O O Q L
U U U.Ll C LI,
Shows MIDI receive channel numoer.
(Example here indicates channel 1.)
• The selected program number is maintained when
the power is turned off. The displayed program
number is the most recently selected program