Network And Voice Configuration - Net2Phone Max 410 User Manual

Max 410/420/430

4.1 Network and Voice Configuration

Any parameters on the Network and Voice Configuration
page can be modified by simply entering the desired
values into the respective boxes.
The IP Configuration table displays all the Max
410/420/430's IP-related parameters.
The Voice Configuration table displays the Jitter Buffer
Bounds, which are used to control Quality of Service
(QoS). The default values in this table should not
normally be changed.
DHCP users: If your LAN is using DHCP addresses,
you do not have to configure this page. You may
proceed directly to Configuring Accounts, below.
Static address users: Your IP address and Subnet
netmask are already present in the IP Configuration
table (you entered them previously). Now you need to
enter the additional IP parameter information you
obtained from your LAN administrator:
•
Default Gateway
•
DNS Server IP (Primary)
•
DNS Server IP (Secondary)
•
Domain Name (if applicable)
The Network Configuration table displays the doorman
IP addresses and ports, and the TCP/UDP start ports.
NOTE: If a default gateway address
or a DNS server address is not
used the value 0.0.0.0 must be
entered into their respective boxes.
If the boxes are left blank the
modified configuration settings will
not be saved.
31