The active directory changes to
/config/ip
n2p:/config/ip>
3. Type
S
410's IP address and netmask are listed
on the screen. Write them down and keep
them for future reference.
If your LAN uses DHCP, you are now ready to
finish setting up the Max 410/420/430 using the
Max Web Manager. Proceed to Section 3,
Logging In to the Max Web Manager.
2.2 Connecting to a LAN with Static IP
Addresses
This section explains how to connect your Web browser
to the Max 410/420/430 if your LAN uses static IP
addresses, using either a telephone keypad or serial
connection. The process will entail the following steps:
1. Disable DHCP in the Max 410/420/430.
2. Enter a static IP address.
3. Enter a netmask address.
4. Reset the unit.
5. Log in to the Max Web Manager.
6. Set the required configuration parameters in
the Max Web Manager.
2.2.1 Entering Static IP addresses from a
Telephone Keypad
If your LAN uses static IP addresses, the most
practical way to set up the Max 420 is to enter an IP
address and netmask from a telephone keypad. You
can then finish setting up the unit while browsing the
Max Web Manager.
User's Guide Section 2
and the prompt becomes
.
followed by the R R R R key. The Max
18