Obtaining The Max 420/430'S Dhcp Ip Address Via A Telephone Keypad - Net2Phone Max 410 User Manual

assigned to the unit by the LAN before you can browse
the Max Web Manager, Max 410/420/430's Web-based
configuration system. If your LAN is using DHCP,
configuring the Max 410/420/430 will entail the following
steps:
1. Obtain the Max 410/420/430's current IP
address (Section 2.1.1).
2. Log in to the Max Web Manager.
3. Set the required configuration parameters in
the Max Web Manager.
2.1.1 Obtaining the Max 420/430's DHCP IP
Address via a Telephone Keypad
The handiest way to query the Max 420's current IP
address is usually from a telephone keypad (if an FXS
port is present). To use this procedure you will need a
standard analog corded or cordless touch-tone
telephone. Get a pencil and paper to write down the IP
address.
1. Connect an analog telephone to any FXS
port on the Max 410/420/430.
2. Pick up the telephone handset and dial
(***1 on the keypad). The voice prompt
responds: "Your address is..." and the IP
address is announced.
3. Write down the address and hang up the
telephone. If you need to hear the address
again, hang up the telephone, then repeat
step 2.
You are now ready to finish setting up the Max
410/420/430 using the Max Web Manager. Proceed
to Section 3, Logging In to the Max Web Manager.
User's Guide Section 2
14
***
1