Entering Static Ip Addresses Via Hyperterminal (Max 410) - Net2Phone Max 410 User Manual

The telephone keypad configuration parameter codes
are as follows:
Read IP address
Assign static IP address
Assign netmask
2.2.2 Entering Static IP Addresses via
HyperTerminal (Max 410)
Although many of the Max 410's IP parameters can
be set manually through the serial connection, if
desired, this section will only show you how to set
the IP address and netmask parameters. The
procedure is as follows.
NOTE: For Max 410 units, LAN
settings can only be configured
by this method.
2.2.2.1 Turning DHCP On (or Off) from
HyperTerminal
The Max's default DHCP setting is DCHP enabled.
Before you can enter a static IP address, you must
first disable DHCP. (The same procedure is used to
re-enable it, if necessary.)
1. Follow the procedures in Section 2.1.2.1
and 2.1.2.2, above, to start your
HyperTerminal connection.
2. After logging in:
User's Guide Section 2
***
1 DHCP disable
***
2 DHCP enable
***
3
22
***
5
***
4