Comtrend Corporation CT-5364A User Manual page 68

802.11n adsl2+ router
Hide thumbs Also See for CT-5364A:
Table of Contents

Advertisement

Field
Rule Order
Rule Status
Assign Classification
Queue
Assign Differentiated
Services Code Point
(DSCP) Mark
Mark 802.1p if
802.1q is enabled
SET-1
Physical LAN Port:
Protocol
Differentiated
Services Code Point
(DSCP) Check
IP Address
Source Subnet Mask
UDP/TCP Source Port
(port or port:port)
Destination IP
address
Destination Subnet
Mask
UDP/TCP Destination
Port (port or
port:port)
Source MAC Address
Source MAC Mask
Destination MAC
Address
Destination MAC
Mask
SET-2
802.1p Priority
Description
Last or null are the only options.
Disable or enable the rule.
The queue configurations are presented in this format:
"Interfacename&Prece P&Queue Q" where P and Q are the
Precedence and Queue Key values for the corresponding
Interface as listed on the Queue Config screen.
The selected Code Point gives the corresponding priority to
the packets that satisfies the rules set below.
Select between 0-7. The lower the digit shows the higher
the priority.
Select eth0-eth4 or Wlan from the dropdown menu.
TCP, TCP/UDP, UDP, or ICMP.
The selected Code Point gives the corresponding priority to
the packets that satisfies the rules set below.
Select IP Address, Vendor Class ID (DHCP Option 60), or
User Class ID (DHCP Option 77)
Enter the subnet mask for the source IP address.
Enter source port number or port range.
Enter destination IP address.
Enter destination subnet mask.
Enter destination port number or port range.
A packet belongs to SET-1, if a binary-AND of its source MAC
address with the Source MAC Mask is equal to the
binary-AND of the Source MAC Mask and this field.
This is the mask used to decide how many bits are checked
in Source MAC Address.
A packet belongs to SET-1 then the result that the
Destination MAC Address of its header binary-AND to the
Destination MAC Mask must equal to the result that this field
binary-AND to the Destination MAC Mask.
This is the mask used to decide how many bits are checked
in Destination MAC Address.
Select between 0-7. The lower the digit shows the higher
the priority
67

Advertisement

Table of Contents
loading

Table of Contents