Table of Contents
Advertisement
2.2 LED I ndicators
The front panel LED indicators are shown below and explained in the following table.
This information can be used to check the status of the device and its connections.
LED
Color
Green
POWER
Red
LAN 4X-1X
Green
WPS
Green
Wireless
Green
ETH WAN
Green
ADSL
Green
Green
INTERNET
Red
Mode
On
The device is powered up.
Off
The device is powered down.
POST (Power On Self Test) failure or other
malfunction. A malfunction is any error of internal
On
sequence or state that will prevent the device from
connecting to the DSLAM or passing customer data.
On
An Ethernet Link is established.
Off
An Ethernet Link is not established.
Blink
Data transmitting or receiving over LAN.
On
WPS enabled.
Off
WPS disenabled.
Blink
The router is searching for WPS clients.
On
The wireless module is ready.
(i.e. installed and enabled).
The wireless module is not ready.
Off
(i.e. either not installed or disabled).
Blink
Data transmitting or receiving over WLAN.
On
An Ethernet WAN Link is established.
Off
An Ethernet WAN Link is not established.
Blink
Data transmitting or receiving over Ethernet WAN.
On
The ADSL link is established.
Off
The ADSL link is not established.
Blink
The ADSL link is training.
On
IP connected and no traffic detected. If an IP or
PPPoE session is dropped due to an idle timeout, the
light will remain green if an ADSL connection is still
present.
Off
Modem power off, modem in bridged mode or ADSL
connection not present. In addition, if an IP or
PPPoE session is dropped for any reason, other than
an idle timeout, the light is turned off.
Blink
IP connected and IP Traffic is passing thru the device
(either direction)
Device attempted to become IP connected and failed
On
(no DHCP response, no PPPoE response, PPPoE
authentication failed, no IP address from IPCP, etc.)
10
Function
Advertisement
Table of Contents
