Table of Contents
Advertisement
.
.
S
tep 9 – Attach Reflector Assembly to Studs
Support Heater.
Slide 3 M 8 Flat Washers over threaded end
Reflector Studs.
6 M8 Flat Washers
.
Place Reflector Assembly on 3 studs.
Install M8 Flat W ashers on studs & securely tighten
wing nuts but do not over-tighten!
.
Step 10 – Connect Hose & Regulator to Cylinder
Specifications
You
must
provide
propane
gas
and
propane cylinder. Use a
.
standard 20 lb. propane
cylinder only.
Use this heater only
with a propane vapor
withdrawal
supply
system. See Chapter 5
of
the
Standard
for
Storage and Handling
of Liquefied Petroleum
Gas, ANSI/NFPA 58.
Your local library or
fire department should have this book.
of
3 Wing Nuts
Standard 20 lb. tank
NOT INCLUDED
The minimum permissible gas supply pressure of
10 W.C. is required for purpose of input adjustment.
The minimum hourly of 17000 BTU is required
.
rating for a heater for automatic operation at ratings
less than full input rating.
.
The pressure regulator and hose assembly supplied
w ith the appliance must be used.
The installation must conform with local codes, or in
.
the absence of local codes, with National Fuel Gas
Code, ANSI Z223.1.
A dented, rusted or damaged propane cylinder may
be hazardous and should be checked by your cylinder
.
supplier. Never use a propane cylinder with a
damaged valve connection.
The propane cylinder must be constructed and
marked in accordance with the specifications for LP
.
gas
cylinders
of
the
Transportation (DOT).
.
Never connect an unregulated propane cylinder to the
heater.
Screw regulator onto gas hose. Do not cross-thread.
Tighten securely.
Attach regulator to cylinder.
Complete attachment.
Install cylinder.
U.S.
Department
of
7
Hide quick links:
Advertisement
Table of Contents
