Table of Contents
Advertisement
Insert Sand Box inside Base and screw on M8 nut.
Tighten with Philips screwdriver.
For best stability, fill the sand box with sand.
Step 3 – Attach L-Shaped Brackets to Base
Attach L-Shaped Brackets loosely to Base with 4 pcs
M8x12 Hex Bolts and 4 pcs M8 Flat Washers. (NOTE:
L-shaped Brackets will be used to help secure the
Cylinder Housing to the Base in Step 4 below)
Step 4 – Attach Post to Cylinder Housing Top and Attach
Cylinder Housing to base
Slide the post up through the bottom of the Cylinder Housing
and out through the hole on the top of the Cylinder Housing
and attach the post to the Cylinder Housing using 4 pcs
M6x12 Hex Bolts and 4 pcs M6 Flange Nuts. Slide the Plastic
Ring over the Post and secure it on the bolts on the top of the
Cylinder Housing. Attach the Cylinder Housing/Post assembly
to the L-Shaped Brackets on the Base with 8 pcs M5x10
Round Head Screws and 8 pcs M5 Flange Nuts.
For models without table, skip to Step 6.
Step 5 – Table Installation
Slide part 4 over Post and
down onto Cylinder Housing.
Slide Part 3 down over post
and onto Part 4. Then slide
Table (Part 2) over post and
rest on Part 3.
Now slide Part 1 down over post and through hole
in Table. Hold the Table with your hand and screw
Part 1 into Part 3.
To adjust the height of the Table, loosen the
plastic nut and move Table to desired height.
Tighten plastic nut.
Step 6 – Attach Reflector Studs to Head Assembly
Insert 3 Reflector Studs and 3 Flat Washers onto top of
Head Assembly. Tighten Studs securely.
5
Hide quick links:
Advertisement
Table of Contents
