Step 7 - Attach Head Assembly To Post; Step 8 - Install Reflector - Fire Sense 61280 Owner's Manual

Step 7 – Attach Head Assembly to Post
Unscrew 4 Small Bolts and 4 Lock Washers
pre-assembled in Head Assembly.
4 Small Bolts
4 Lock Washers
.
.
Load Head Assembly by inserting hose into post.
Insert Head Assembly into post.
Control knob should be above decal on post.
.
Attach Head Assembly to post, and loosely install four
small bolts and lock washers.
.
Tighten bolts securely.
Step 8 – Install Reflector
WARNING
Remove protective cover before assemble.
Note: If necessary for proper alignment of reflector
.
sections, loosen each screw prior to further assembly and
r etighten after sections are align
Slide two Reflector
Panels together.
6
.
ed.
Insert M6x10 Flat Head
Screw.
9 M6x10 Flat Head Screws
Screw on M6 Cap Nut loosely.
.
.
Slide Reflector Plate
onto Reflector Panels.
Insert one M6x10
Flat Head Screw.
.
.
Repeat procedure to complete the assembly of all four
sections.
Fully tighten all of the screws in the rolled edge.
9 M6 Cap Nuts
.
Screw on M6 Cap Nut
loosely.