Additional Requirements; Installation Process; Step1 - Attach Wheel Assembly To Base; Step 2 - Attach Sand Box To Base - Fire Sense 61280 Owner's Manual

Hardware
Picture Qty
4
4
8 M6x10 Round Head Screw
8
9
9 M6x10 Flat Head Screw
3
3
4
*Pre-inserted in Head Assembly
4
*Pre-inserted in Head Assembly
4
*Pre-assembled to base with
6
*4 pcs. pre-assembled to base
6
13
4
1
1 Plastic Fastener (optional)
1

Additional Requirements

The following items are not included, but are necessary for
.
the proper assembly of your heater. Do NOT attempt to
.
assemble without proper tools.
.
Philips screwdriver w/ medium blade.
Adjustable opening wrench.
Leak Detection Solution (Instructions on how to make
solution are included on page 8 )
Note: You must follow all steps to properly assemble
heater.
4
Description Used in
Step(s)
M6x12 Hex Bolt
M6 Flange Nut
M5 Flange Nut
M6 Cap Nut
Wing Nut
Reflector Stud
Small Bolt
Lock Washer
M8 Flat Head Screw
sand box
M8 nut 1/2
with sand box
M8x12 Hex Bolt 1/3
M8 Flat Washer 3/6/9
L-Shaped Bracket
Plastic Ring
Wrench
needed
4

Installation process

4
4
.
4
S tep 1 – Attach Wheel Assembly to Base
Line up holes in Wheel Bracket with corresponding
8
.
holes in Base and insert 2 - M 8 x 1 2 B o l t s through holes.
Finger tighten the bolts.
8
Be sure that the Wheel Assembly is parallel to the
9
base, and fully tighten bolts
6
7
7
2
2 M8x12 Hex Bolts
3
4
5
For best stability, fill the sand box with sand.
For models with sand box pre-assembled to
As
the base, skip to Step 3.
Step 2 – Attach Sand Box to Base
.
Slip 4 M8 Flat Head Screws through holes of Base.
4 M8 Flat Head Screws
Assembly time: 40 minutes
.
Wheel Assembly
4 M8 Nuts