Download Print this page
Fire Sense 60523 Manual

Fire Sense 60523 Manual

Pyramid flame heater
Hide thumbs Also See for 60523:

Advertisement

Quick Links

Comfort, Quality & Style Since 1998
Pyramid
Heater
Before returning to your retailer, our exceptional customer service is available.
0706

Advertisement

loading
Need help?

Need help?

Do you have a question about the 60523 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Fire Sense 60523

  • Page 1 Comfort, Quality & Style Since 1998 Pyramid Heater Before returning to your retailer, our exceptional customer service is available. 0706...
  • Page 2 Please read and understand this entire manual before attempting to assemble, operate or install this appliance. his manual contains important information about the assembly, operation and maintenance of this patio heater. manual for future reference and to educate new users of this appliance. This manual should be read in conjunction with the labeling on the appliance.
  • Page 4 Pre-assembled in respective eyelets...
  • Page 5 (pre-assembled)
  • Page 7 Remove from Studs in the top of the Screw Studs into holes in over the Studs and screw on secure (pre-assembled in Emitter Screen) 3x Studs 3x Wing Nuts...
  • Page 8 Remove blue protective film from all panels before installation. Note: SIDE panels have ventilation holes while BACK panel has no vents. Do not cover the front, where the control knob is. Note: The chain is used to support the door panel while operating the controls.
  • Page 9 NOTE: The regulator with gas hose is supplied.
  • Page 10 Note: Whenever gas connections are loosened or removed, you must perform a complete leak test. Caution: Do not attempt to operate this appliance until you have read and understand all Safety Information in this manual and all assembly is complete and leak tests have been performed.
  • Page 12 FOR YOUR SAFETY Be careful when attempting to manually ignite this heater. Holding in the control NOTE: For initial start or after any cylinder knob for more than 10 seconds before change, hold the control knob in for 2 upon ignition. minutes to purge air from all gas lines PILOT before proceeding.
  • Page 13 NOTE: After use, some discoloration of the emitter screen is normal.
  • Page 14 Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for corroded areas and repair them promptly. Use high-quality automobile wax to help maintain the appearance of your heater. Apply to exterior surfaces from the post down. DO NOT apply to emitter screen or domes.
  • Page 16 an additional year...

This manual is also suitable for:

62263