Configuring A Default Radius Server; Figure 433 Object > Aaa Server > Radius > Default; Table 214 Object > Aaa Server > Radius > Default - ZyXEL Communications ZyWALL USG 300 User Manual

Table 213 Object > AAA Server > Active Directory (or LDAP) > Group > Add (continued)
LABEL
Add icon
OK
Cancel

40.4 Configuring a Default RADIUS Server

To configure the default external RADIUS server to use for user authentication, click Object
> AAA Server > RADIUS to display the screen as shown.
Figure 433 Object > AAA Server > RADIUS > Default
The following table describes the labels in this screen.
Table 214 Object > AAA Server > RADIUS > Default
LABEL
Host
Authentication
Port
Key
Timeout
Apply
Reset
ZyWALL USG 300 User's Guide
DESCRIPTION
Click Add to add a new AD or LDAP server. You can add up to four AD or LDAP
member servers.
Click Delete to remove an AD or LDAP server.
Click OK to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Enter the IP address (in dotted decimal notation) or the domain name (up to 63
alphanumeric characters) of a RADIUS server.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator instructs you to do
so with additional information.
Enter a password (up to 15 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyWALL.
The key is not sent over the network. This key must be the same on the external
authentication server and the ZyWALL.
Specify the timeout period (between 1 and 300 seconds) before the ZyWALL
disconnects from the RADIUS server. In this case, user authentication fails.
Search timeout occurs when either the user information is not in the RADIUS server
or the RADIUS server is down.
Click Apply to save the changes.
Click Reset to start configuring this screen again.
Chapter 40 AAA Server
613