Interface Technical Reference; Figure 148 Example: Entry In The Routing Table Derived From Interfaces; Table 75 Example: Routing Table Entries For Interfaces - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

Table 74 Network > Interface > Auxiliary (continued)

Authentication

Idle timeout

10.16 Interface Technical Reference

Here is more detailed information about interfaces on the ZyWALL.

IP Address Assignment

Most interfaces have an IP address and a subnet mask. This information is used to create an

entry in the routing table.

IP ADDRESS(ES)

100.100.1.1/16

200.200.200.1/24

For example, if the ZyWALL gets a packet with a destination address of 100.100.25.25, it

routes the packet to interface ge1. If the ZyWALL gets a packet with a destination address of

200.200.200.200, it routes the packet to interface ge2.

In most interfaces, you can enter the IP address and subnet mask manually. In PPPoE/PPTP

interfaces, however, the subnet mask is always 255.255.255.255 because it is a point-to-point

interface. For these interfaces, you can only enter the IP address.

ZyWALL USG 300 User's Guide

Enter the password again to make sure you have not typed it incorrectly.

Select the authentication protocol to use for outgoing calls. Choices are:

CHAP/PAP - Your ZyWALL accepts either CHAP (Challenge Handshake

Authentication Protocol) or PAP (Password Authentication Protocol), as

requested by the computer you are dialing.

CHAP - Your ZyWALL accepts CHAP only.

PAP - Your ZyWALL accepts PAP only.

MSCHAP - Your ZyWALL accepts MSCHAP only.

MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.

Type the number of seconds the ZyWALL tries to set up a connection before it

stops. Allowed values are 30 - 120.

Type the number of seconds the ZyWALL should wait for traffic before it

automatically disconnects the connection. Set this field to zero to disable the

idle timeout. Allowed values are 0 - 360.

Chapter 10 Interface