How To Configure Load Balancing; Figure 48 Network > Interface > Port Grouping, Drag-And-Drop (P5 To Ge4); Figure 49 Status: Interface Status Summary After Port Grouping - ZyXEL Communications ZyWALL USG 300 User Manual

Figure 48 Network > Interface > Port Grouping, Drag-and-Drop (P5 to ge4)
3 Click Apply.
4 Click Status, and look at the Interface Status Summary as shown next. Ethernet
interface ge4 has a status of Port Group Up if it is connected or Port Group Down if it
is not connected. Ethernet interfaces ge5 has a Status of Port Group Inactive.

Figure 49 Status: Interface Status Summary After Port Grouping

6.2 How to Configure Load Balancing

With the topology in
upstream Internet connection (100 Mbps) while ge2 and ge3 have just 1 Mbps each. You want
the ZyWALL to use ge7 for most Internet traffic and only use interfaces ge2 and ge3 for any
traffic that exceeds what ge7 can handle.
ZyWALL USG 300 User's Guide
Figure 45 on page 123, suppose interface ge7 has a high bandwidth
Chapter 6 Tutorials
125