ZyXEL Communications ZyWALL USG 300 User Manual page 154

Chapter 7 Status
Table 31 Status (continued)
LABEL
Device
Status
System Status
System Uptime
Current Date/
Time
VPN Status
DHCP Table
Port Statistics
Current Login
User
Number of Login
Users
Boot Status
Licensed Service
Status
IDP
License
Status /
Remaining
days
Signature
Version
Last Update
Time
154
DESCRIPTION
This field displays the name of the device connected to the extension slot (or none
if no device is detected).
For installed cellular (3G) cards, this field displays the card's current status. See
Table 56 on page 205.
This field displays how long the ZyWALL has been running since it last restarted or
was turned on.
This field displays the current date and time in the ZyWALL. The format is yyyy-
mm-dd hh:mm:ss.
Click this to look at the VPN tunnels that are currently established. See
7.2.4 on page 158.
Click this to look at the IP addresses currently assigned to the ZyWALL's DHCP
clients and the IP addresses reserved for specific MAC addresses. See
7.2.5 on page 159.
Click this to look at packet statistics for each Gigabit Ethernet port. See
7.2.6 on page 160.
This field displays the user name used to log in to the current session, the amount
of reauthentication time remaining, and the amount of lease time remaining. See
Chapter 36 on page 575.
This field displays the number of users currently logged in to the ZyWALL. Click the
icon to pop-open a list of the users who are currently logged in to the ZyWALL. See
Section 7.2.8 on page 163.
This field displays details about the ZyWALL's startup state.
OK - The ZyWALL started up successfully.
Firmware update OK - A firmware update was successful.
Problematic configuration after firmware update - The application of the
configuration failed after a firmware upgrade.
System default configuration - The ZyWALL successfully applied the system
default configuration. This occurs when the ZyWALL starts for the first time or you
intentionally reset the ZyWALL to the system default settings.
Fallback to lastgood configuration - The ZyWALL was unable to apply the
startup-config.conf configuration file and fell back to the lastgood.conf configuration
file.
Fallback to system default configuration - The ZyWALL was unable to apply the
lastgood.conf configuration file and fell back to the system default configuration file
(system-default.conf ).
Booting in progress - The ZyWALL is still applying the system configuration.
This field displays the current status of the license and how many days longer it is
still valid. If it displays 0 days, the license has expired. If the status is not Licensed,
click this to open the screen where you can activate or extend the license. See
Section 8.2 on page 166.
This field displays the version number, date, and time of the current set of
signatures the ZyWALL is using.
This field displays the last time the ZyWALL received updated signatures.
Section
Section
Section
ZyWALL USG 300 User's Guide