Vlan Summary Screen; Figure 142 Network > Interface > Vlan; Table 66 Network > Interface > Vlan - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

Each VLAN interface is created on top of only one Ethernet interface.

Otherwise, VLAN interfaces are similar to other interfaces in many ways. They have an IP

address, subnet mask, and gateway used to make routing decisions. They restrict bandwidth

and packet size. They can provide DHCP services, and they can verify the gateway is

10.12.3 VLAN Summary Screen

This screen lists every VLAN interface and virtual interface created on top of VLAN

interfaces. To access this screen, click Network > Interface > VLAN.

Figure 142 Network > Interface > VLAN

Each field is explained in the following table.

Table 66 Network > Interface > VLAN

ZyWALL USG 300 User's Guide

This field is a sequential value, and it is not associated with any interface.

This field displays the name of the interface.

For VLAN interfaces, this field displays

the Ethernet interface on which the VLAN interface is created

For virtual interfaces, this field is blank.

This field displays the current IP address of the interface. If the IP address is

0.0.0.0, the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address (STATIC)

or dynamically assigned (DHCP). IP addresses are always static in virtual

This field displays the interface's subnet mask in dot decimal notation.

This column lets you create, edit, remove, activate, and deactivate interfaces.

To create a VLAN interface, click the Add icon at the top of the column. The

VLAN Add/Edit screen appears.

To create a virtual VLAN interface, click the Add icon next to the corresponding

VLAN interface. The Virtual Interface Add/Edit screen appears. See

10.13 on page

To edit an interface, click the Edit icon next to it. The VLAN Add/Edit screen or

Virtual Interface Add/Edit screen appears accordingly.

To remove an interface, click the Remove icon next to it. The ZyWALL confirms

you want to remove it before doing so.

To activate or deactivate an interface, click the Active icon next to it. Make sure

you click Apply to save and apply the change.

Chapter 10 Interface