Outgoing calls
Direct dial
With direct dialling, a timer is restarted after every digit pressed. The timer auto-
matically starts dialling after the time specified (the factory setting is 5 seconds).
The time can be configured by web configuration.
Pick up the receiver and wait for the dialling tone
Use the numeric keypad to enter the phone number required
Start dialling with "OK" or "Dial", or simply wait for the timer to expire
Indirect dial (dial preparation)
Here the digits entered are not dialled immediately. This means you are able make
corrections to the number before you dial.
Use the numeric keypad to enter the required number
To dial a telephone number entered, pick up the receiver. The connection
is established and you can make your call
Dialling with speed dial keys
Press one of the function keys assigned function "Speed dial" or "Busy lamps" and
then pick up the receiver
Note:
If you do not pick up the handset, the connection is automatically
established after pressing the function key in hands-free mode, or if
a non DHSG-compatible headset is active, with the headset.
Once you have picked up the receiver and then pressed the speed dial key, the
phone establishes the connection after a configurable time on pressing the speed
dial key (the factory setting is 5 seconds). Pressing the # key establishes the
connection immediately.
Dialling from the phone book
Press the Phone register key, select a contact and then pick up the receiver. If
only one number is stored for the contact, the number is then dialled. If multiple
numbers are stored for a contact, you are shown the numbers for selection. Use
the up and down control keys to select the required number and then press the
"Dial" softkey to establish the connection.
Outgoing calls
22