The system will answer an incoming call after a number of rings. Sharing the phone line with fax or alarm system, disable this code.
1.
Log-in to programming
2. Enter 38 then #
3. Press
0= disable auto answer
1-9= answer in 1-9 rings
then press #
Function Code 39 Disable and Enable Remote Access
If no remote opening allow, disable it using this function code. Default setting is enabled.
1.
Log-in to programming
2. Enter 39 then #
3. Press
0= disable remote access
1= enable remote access (default)
then press #
Function Code 40 DTMF Relay 1
By default the DTMF remote opening relay 1 (door 1) key number is set to 9 means pressing 9 will remotely trigger relay 1 (door 1). The number can be changed by
selecting 1-9 to trigger relay 1 (door 1).
MUST change relay 2 to different key number even though relay 2 is not used.
1.
Log-in to programming
2. Enter 40 then #
3. Press 1-9 (9 is default setting) then press #
Function Code 41 DTMF Relay 2
By default the DTMF remote opening relay 2 (door 2) key number is set to 8 means pressing 8 will remotely trigger relay 2 (door 2). The number can be changed by
selecting 1-9 to trigger relay 2 (door 2).
MUST change relay 1 to different key number even though relay 1 is not used.