Table of Contents
Advertisement
Digital Projection
M-Vision Cine 320 3D Series
Control Connections
Service port
The service port is used to download firmware updates issued from
time to time by Digital Projection.
LAN and RS232
All of the projector's features can be controlled via a LAN or
serial connection using the text strings described in the Remote
Communications Guide.
Connecting to the projector via a web-based interface is described in
the next chapter, LAN IP configuration utility.
Wired remote control
You can connect a wired remote control to the projector via a 3.5mm
jack. You can also use this socket to connect an external IR repeater if
needed.
Trigger 1 and 2 outputs
The Trigger outputs are activated by one of the three following
conditions, as set in the Control menu:
•
Screen trigger: can be connected to an electrically operated
screen, automatically deploying the screen when the projector
starts up, and retracting the screen when the projector shuts
down.
•
Aspect ratio trigger: can be used to control screen shuttering for
different aspect ratios.
•
RS232 trigger: can be used to control the screen or screen
shuttering on receipt of an RS232 command.
3D Sync output
Connect the Sync Out connector to a Z Screen or 3D IR emitter as
appropriate.
Rev E July 2014
CONTROL CONNECTIONS
Trigger 1 output
Wired remote
LAN
Trigger 2 output
3D sync output
For a complete listing of pin
configurations for all signal and
control connectors, see Wiring
Details later in this guide.
Plugging in the wired remote control
disables the infrared.
RS232
Service port
Connection Guide
Notes
19
Advertisement
Table of Contents
