Notices; Electrical Safety - IBM 6400 Maintenance Information Manual

Notices

E S
Note: The NERGY TAR emblem does not represent EPA endorsement of
any product or service.
Notices
References in this publication to IBM products, programs, or services do not
imply that IBM intends to make these available in all countries in which IBM
operates. Any reference to an IBM licensed product, program, or service is
not intended to state or imply that only IBM's product, program, or service
may be used. Any functionally equivalent product, program, or service that
does not infringe any of IBM's intellectual property rights may be used instead
of the IBM product. Evaluation and verification of operation in conjunction with
other products, except those expressly designated by IBM, is the user's
responsibility.
Any performance data contained in this document was obtained in a
controlled environment based on the use of specific data. The results that
may be obtained in other operating environments may vary significantly.
Users of this document should verify the applicable data in their specific
environment. Therefore, such data does not constitute a performance
guarantee or warranty.
IBM may have patents or pending patent applications covering subject matter
in this document. The furnishing of this document does not give you any
license to these patents. You can send license inquiries, in writing, to the IBM
Corporation, IBM Director of Licensing, 208 Harbor Drive, Stamford,
Connecticut, United States, 06904.

Electrical Safety

This printer is inspected and listed by recognized national testing laboratories,
such as Underwriters Laboratories, Inc. (UL**) in the U.S.A. and Canadian
Standards Association (CSA**) in Canada. Listing of a product by a national
testing laboratory indicates that the product is designed and manufactured in
accordance with national requirements intended to minimize safety hazards.
IBM equipment meets a very high standard of safety in design and
manufacture. Remember, however, that this product operates under
conditions of high electrical potentials and heat generation, both of which are
functionally necessary.