IBM 6400 Maintenance Information Manual page 73

Operator Panel
Message
031 END OF FORMS
TIMEOUT
LOAD FORMS
Table 4. Message List
Explanation
On a coax interface, a
timeout message is
sent to the host if
paper is not loaded
within 10 minutes
after Stop was
pressed to clear an
end of forms fault.
Corrective Action
1. Load paper. Press Stop. If message
does not clear, go to the next step.
2. Power off the printer. Remove the paper
guide assembly or pedestal top cover.
Remove the barrier shield (cabinet
model) or the barrier shield and paper
guide (pedestal model). Check that the
paper detector switch assembly is
securely mounted in its bracket.
3. Check that connector P106/PMD is fully
seated in connector J106 on the CMX
controller board.
4. Power on the printer. Load paper.
Replace the paper detector switch
assembly if the message appears.
5. Power on the printer. Load paper.
Replace the CMX controller board if the
message appears. Record the message
and return it with the defective board.
Message List
73