Operator Panel Assembly, Cabinet Model - IBM 6400 Maintenance Information Manual

Operator Panel Assembly, Cabinet Model

Removal
1. Prepare the printer for maintenance (page 152).
2. Open the printer cover.
3. Remove the four screws securing the operator panel plate to the panel
bracket. (See Figure 42, page 254.)
4. Press down on the plastic tab at the upper rear of the panel and slide the
operator panel downward on the mounting plate until the tabs on the
panel housing slide out of the cutouts.
5. Lift the operator panel assembly and disconnect the phone-style cable
connector.
Installation
1. Connect the phone-style operator panel cable to the bottom of the
operator panel. (See Figure 42, page 254.)
2. Position the operator panel over the cutouts in the panel plate. Slide the
panel upward until the plastic tab at the upper rear of the panel locks into
the mounting plate.
3. Position the operator panel and plate on the bracket and install the four
screws finger tight. (See Figure 42, page 254.)
4. Slowly lower the printer cover and align the operator panel in the cover
cutout. Open the printer cover and tighten the panel plate screws.
5. Return the printer to normal operation (page 153).

Operator Panel Assembly, Cabinet Model

227