IBM 6400 Maintenance Information Manual page 180

Chapter 6
Loading Flash Memory
Message
ERROR: WRITING
TO FLASH
ERROR: WRONG
CHECKSUM
ERROR OCCURRED
FLUSHING QUEUES*
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM
INTO FLASH
RESETTING . . .
PLEASE WAIT
RESTORING
BOOT CODE
SECURITY CODE
VIOLATION
SENDING PROGRAM
TO EC PROCESSOR
TABLE MISMATCH
DOWNLOAD AGAIN
180
Table 7. Flash Memory Message Guide
Explanation
Hardware or software fault in flash
memory.
The printer received the complete
program but the checksum did not
match. The data were corrupted
during download.
An interim message that displays
while the printer discards host data it
cannot use because a fault condition
exists. While this message displays,
the asterisk (*) rotates.
The new program is loading into
printer RAM. XX indicates how much
of the program has loaded.
The printer has deleted the previous
program from flash memory and is
loading the new program into flash
memory.
The printer finished loading the
program into flash memory and is
automatically resetting itself.
Normal download initialization
message.
The software running or being
downloaded does not match the
security PAL code.
The printer is loading the engine
controller program into the engine
controller.
EC software update in process.
Required
Action
Download the program
again: Power off the
printer and start over at
step 12. If the message
occurs again, replace the
flash memory.
Download the program
again: Power off the
printer and start over at
step 12.
Wait. When the asterisk
(*) stops rotating, a
different fault message
will appear: troubleshoot
the final message.
None
None
None
None
Install the correct PAL or
program. (PAL and
program must match.)
None
Download the program
again: Power off the
printer and start over at
step 12.