IBM 6400 Maintenance Information Manual page 196

Chapter 7
Section I: Replacement Procedures
Installation
1. Position the cable connector in the connector shell. Two-wire connectors
are always grouped across from two-wire connectors in a connector shell.
Four-wire connectors are always grouped across from four-wire
connectors in a connector shell. (See Figure 30.)
2. Pull the side of the connector shell outward and gently push the cable
connector down into the connector shell.
3. Engage the tabs on the cable connector in the slots in the side of the
connector shell. Press the sides of the connector shell inward to make
sure all cable connector tabs are engaged in the shell slots.
NOTE: Later models have stiffening clips on connectors P106 and P107.
4. On later model printers, install the stiffening clip (page 198).
5. Connect the cable connector shell to its printer connection.
6. Cabinet Model: Install the paper guide assembly (page 229).
Pedestal Model: Install the top cover assembly (page 204).
7. Return the printer to normal operation (page 153).
196