Advertisement
You may need to remove the lens cover from the camera to access the
reset button, microSD card, or focus the camera.
Unfasten the screw on the camera housing and remove the front
cover
To prevent condensation on the glass cover, the HD90IR has a
desiccant packet installed inside the housing of the camera. If
condensation appears, replace the desiccant packet with the
replacement packet included in your camera packaging
1.
Unfasten the screw on the camera housing and remove the front
cover
2.
Remove the desiccant packet from the camera.
3.
Carefully tear open the aluminum envelope for the new packet, and
remove the desiccant.
4.
Remove paper backing from the adhesive strip on the desiccant
packet.
5.
Place the desiccant firmly in the position indicated here.
6.
Reinstall the front cover and fasten the screw
32332AB
If it is necessary to reset the camera to the factory default settings, hold
down the Reset button (see Camera Overview) for 30 seconds. This will
return all settings, including network setup, to the factory default. The IP
address of the camera will return to 192.168.0.250.
Your camera includes a microSD card clot (up to 16GB), which can be
used for emergency video backup. The microSD card is not included.
You must remove the cover of the camera to access the microSD card
slot.
Instructions for recording to a microSD card slot can be found at
avertx.com/support.
SD CARD
SLOT
RESET
BUTTON
15
Advertisement
