Advertisement
The camera can be installed directly onto the wall or ceiling. Be sure
that the structure is strong enough to support the camera.
Bullet cameras are suitable for mounting on either a wall or ceiling.
1.
Use the included mounting template to pre-drill holes for the
mounting screws and, if passing the cable through the ceiling or
wall, drill a ¾" hole.
2.
Connect the Ethernet cable from ceiling or wall to the dongle on the
camera.
Protect the network cable connection from water damage
by running the cord inside a wall or ceiling, or through
conduit
For outdoor installations, seal any holes in the wall or
ceiling with silicone caulk to protect against water
intrusion.
3.
Affix the mounting bracket to the ceiling or wall with the three
supplied self-tapping screws.
Screw
Mounting Bracket Base
4.
Use a Phillips screwdriver to loosen the screw on the side of the
bracket mount.
14
Screw
5.
Adjust the position of your camera.
6.
Tighten the screw to secure your camera.
Adjust aim
Note
HD40IR cameras are equipped with a seal inside the housing
to prevent moisture from entering. If you have any concerns
about moisture entering the housing or wall through the cable
egress, AvertX recommends sealing the opening at the wall
and at the base of the camera with silicone caulking.
Screw
Advertisement
