HD40IR QUICK START GUIDE
About this Guide
This guide is a quick reference for users to install and operate HD40IR Night Vision
HD Indoor/Outdoor Bullet Cameras. It provides only basic information regarding
installation and operation of your camera. For further details, please refer to the
HD40IR User Manual.
CONTENTS
Before proceeding, please check to confirm that the box contains the items listed
here. If any item is missing or has defects, DO NOT install or operate the product and
contact AvertX for assistance.
HD40IR Bullet Camera
Desiccant Envelope
Anchors
Screws
Quick Start Guide & Installation CD
INSTALLATION
Align Holes on Wall
Adjust Aim
The HD40IR camera can be installed directly
onto a wall or ceiling. Be sure that the
structure is strong enough to support the
camera.
1. Remove the HD40IR camera from the
packaging.
2. Connect the Ethernet cable from the
ceiling or wall to the dongle on the
camera.
3. Affix the camera base to the ceiling
or wall with the included self-tapping
screws.
4. Use a Phillips-head screwdriver to loosen
the set screw on the side of the camera
bracket mount.
5. Adjust the position of your camera.
6. Tighten the set screw to secure your
camera.
Note
The HD40IR camera is equipped with
a seal inside the housing to prevent
moisture from entering. If you have
concerns about moisture entering
through the wall via the cable, AvertX
recommends sealing the opening at the
wall and the base of the camera with
silicone caulking.
32334AA