Security Command XR20 User Manual page 21

User Codes
continued
User Code Authority Levels
System Options
Sensor Reset
Outputs On/Off
Bypass Zones
Zone Monitor
System Test
Arm and Disarm
Display Events
Schedules
Date and Time
User Codes
Adding User codes:
1. Access the User Menu.
2. Press the COMMAND key until USER CODES? displays.
3. Press any SELECT key. The keypad displays ADD DEL CHG.
4. Press the SELECT key under ADD to add a new user code.
(You must have a Master user level to add a user to the system.)
5. At the USER NUMBER:
press COMMAND. The displays changes to CODE NO:
6. Enter a user code of 4 digits and press COMMAND. This is the
number the user will use each time they arm, disarm, or make
changes to the system.
Note: If your system is using an access control reader, present the
new user's access device instead of entering a user code.
Standard Master
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√
√
√
- prompt, enter a user number and
7. The display changes to MASTER? NO YES. Select YES to
make this a Master user level with the authority to access all
User Menu functions.
Select NO to make this a Standard user level. The following
options can then be selected:
7a. TEMP CODE
Select NO to make this a permanent user code.
Select YES to make this a temporary code that automatically
expires in 7 days. Temporary codes are ideal for guests or
service technicians. You can delete a Temporary user code
at any time before the 7 day active period ends.
7b. AREAS: . (Displayed in Area systems only).
Enter the area numbers where this user will have access.
For example: if you want this user to only have access to
areas 1 and 2, enter the numbers 1 and 2.
Once the correct area numbers are shown, press Command.
7c. ARM ONLY
Select NO to allow this user to arm and disarm the system
and access all Standard level functions in the User Menu.
Select YES to restrict this user to arming only.
(The Arm Only user code can bypass zones not in a normal
condition at the time of arming.)
.
8. After you've completed making your selections, the keypad
display shows USER # ADDED.
9. Press the ARROW key once to add another user or twice to exit
the User Menu.
NO YES.
NO YES.
User Menu
17