Phoneaccess™ User's Guide; Quick Reference Wallet Card; How It Works - Security Command XR20 User Manual

PhoneAccess™ User's Guide
This exciting feature allows you to call your XR20 system from any outside touchtone phone to arm and disarm protection areas or turn on
or off the panel's relay outputs.

How it works

1. From a touchtone phone, call the XR20 system's phone number.
2. The XR20 answers the call and sounds a short ready tone. You
now have 8 seconds to enter a valid Master user code. If the user
code is accepted by the panel, you'll hear one or more beeps giving
you the current armed status of the system. (You can also find out
the armed status of the system by pressing the * key at any time.)
If
All areas are armed
Area 1 (Perimeter) is armed
Any area is armed
All areas are disarmed
If the user code is not accepted by the panel, you'll hear four short
beeps. Check the user code and try again. After 3 unsuccessful
attempts to enter the code, the panel locks out PhoneAccess™ until
a valid user code is entered at a keypad on the XR20 system.
3. Once the user code is accepted by the panel and the armed status
is given, you can enter the following commands:
Press To do this
#, 1 Arm all areas
#, 2 Arm area 1
#, 3 Arm areas 1 & 2
#, 0 Disarm all areas*
#, 5, 4, 0, n* Toggles the output
(* Use outputs 1, 2, 3, or 4 in place of n)
Note: Zones in a bad condition are force armed when the area arms.
You'll hear
3 short beeps
1 short beep
2 short beeps
1 long beep
You'll hear
3 short beeps
1 short beep
2 short beeps
1 long beep
1 short beep = on
1 long beep = off
4 short beeps = restricted

Quick Reference Wallet Card

PhoneAccess™ Quick Commands
Press To do this
# then 1 Arm all areas
# then 2 Arm area 1
# then 3 Arm areas 1 & 2
Note: Zones in a bad condition are force armed when the area arms.
# then 0 Disarm all areas
#, 5, 4, 0, n* Toggles the output
(* Use outputs 1, 2, 3, or 4 in place of n)
(Enter output descriptions below)
1. _________________________ 3. _________________________
2. _________________________ 4. _________________________
PhoneAccess™ Quick Commands
Press To do this
# then 1 Arm all areas
# then 2 Arm area 1
# then 3 Arm areas 1 & 2
Note: Zones in a bad condition are force armed when the area arms.
# then 0 Disarm all areas
#, 5, 4, 0, n* Toggles the output
(* Use outputs 1, 2, 3, or 4 in place of n)
(Enter output descriptions below)
1. _________________________ 3. _________________________
2. _________________________ 4. _________________________
Cut along dotted lines
You'll hear
3 short beeps
1 short beep
2 short beeps
1 long beep
1 short beep = on
1 long beep = off
4 short beeps = restricted
You'll hear
3 short beeps
1 short beep
2 short beeps
1 long beep
1 short beep = on
1 long beep = off
4 short beeps = restricted
31
Appendix