Table of Contents
Advertisement
Specifications
Gas Supply Requirements
- Australia / New Zealand Only:
Input Rating
(N.H.G.C.)
Supply Pressure
Operating Pressure
Gas
- UK Only:
Heat Input
Nominal
(nett)
Gas Rate
Nominal
(nett)
Supply Pressure
Burner Operating
Pressure
Gas Connection
Appliance Classification
Category:
Flue Type:
*
The burner operating pressure is to be measured at the gas control valve outlet test point
(Refer to Fig 2) with one griddle burner operating at 'High' setting. The operating pressure is
ex-factory set, through the appliance regulator and is not to be adjusted, apart from when
carrying out gas conversion, if required. (Refer to the 'Gas Conversion' section for details).
Gas Connection
Gas supply connection point is located 130 mm from the right hand side of the appliance, 32 mm
from the rear and 655 mm from the floor and is entered from beneath the appliance. An optional
underside connection is available.
Connection is ¾" BSP male.
Natural Gas
GP8910GE/GEC
GP8121GE/GEC
80 MJ/hr
108 MJ/hr
(75,825 BTU)
(102,364 BTU)
1.13 - 3.40 kPa
(4.5" - 13.5" w.c.)
*
0.90 kPa (
(3.6"w.c.)
Natural Gas (G20)
GP8910GE/GEC
GP8121GE/GEC
21 kW
3
2.22 m
/hr
20 mbar
8.2 mbar (*)
II
2H3P.
A
1.
LP Gas (Propane)
GP8910GE/GEC
80 MJ/hr
(75,825 BTU)
)
¾" BSP Male
GP8910GE/GEC
28.5 kW
3
3.02 m
/hr
1.63 kg/hr
3
/
" BSP Male
4
4
GP8121GE/GEC
108 MJ/hr
(102,364 BTU)
2.75 - 4.50 kPa
(11" - 18.0" w.c.)
*
2.6 kPa (
)
(10.2" w.c.)
Propane (G31)
GP8121GE/GEC
21 kW
28.5 kW
2.21 kg/hr
37 mbar
26 mbar (*)
Advertisement
Table of Contents
